Average Customer Review:
( 1 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
1 of 1 found the following review helpful:
Works great!Apr 10, 2012
By Sm1nts2escape I am putting on a new roof and quarter panel on my rx7 project car. There are about 100 spot welds to drill out so I can mig it on. I was able to drill out about 75 of the 100. The tool will only go deep enough to allow your whole about 1/8" from the edge so if you have to have the edge of your hole any deeper than you are going to have to drill or modify the tool. The is room to modify the tool to allow it to punch holes deeper if you wanted. I wish it had a swivel head. This tool helped out alot and made the process much faster. Kept me from bending alot of metal cause I would have had to press hard on the metal to drill the holes. You dont need a big compressor. I used it with a 5 gallon.