| | |  | Gear Pullers | Home » » » Gear Puller / Bearing Splitter - 14 Piece | | | | | | | Description: | | Cast steel bearing splitter and yoke, precision-machined, hardened and tempered steel bolts. Corrosion-resistant black oxide finish, applies even pressure to smoothly separate bearings and remove gears from shaft without damage. Capacities are bearing splitter, minimum spread: 5/8 inch, maximum spread: 2-1/4 inch, puller yoke, width: 7 inch, center bolt: 7 inch x 9/16 inch 1 piece bearing splitter, 2 piece 5 inch x 1/2 inch (12 tpi) draw bolts, 4 piece 6-1/2 inch push puller legs: 3/8 inch (16 tpi) x 5/16 inch (18 tpi), 1 piece puller yoke: 7 inch width, 1 piece 6 inch center screw, 2 piece center screw tips: cone, cylinder, 2 piece 4 inch puller jaws: 3/8 inch (16 tpi) and 1 piece storage case. | | | Features: | |
• Ball bearing splitter
• Black oxide finish
• Resistant to corrosion
• Even pressure to prevent damage
• Drop forged, heat treaded steel attachments
| | | Product Details: | | | Product Length:
| 10.0 inches | | Product Width:
| 13.0 inches | | Product Height:
| 2.0 inches | | Product Weight:
| 9.85 pounds | | Package Length:
| 13.3 inches | | Package Width:
| 10.2 inches | | Package Height:
| 2.0 inches | | Package Weight:
| 10.1 pounds | | Average Customer Rating:
|  based on 2 reviews |
| | | | Customer Reviews: | |
Average Customer Review:
 ( 2 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
 Not worth scrap weight.May 20, 2012
By Mike
This was a real ( TOOL) POS. Not worth the money. Thread size was wrong on the puller, so the attachments would not screw together.
 Pretty good set of pullersOct 26, 2011
By Hiker Biker
"JBHiker"
It does what I need and the case is handy too. I needed something for small gearboxes and motors. The threaded rods and jigs seem like they are pretty good for the size equipment I work on.
| | |
|
