| | |  | Fencing Pliers | Home » » » » MIG 100 Flux Wire Welder | | | | | | | Description: | | 90 Amp Flux wire, 120Volt / 60Hz, ETL approved. No Load Voltage: 31 Volt, adjustment positions: 2 steps. Range of current 50 to 80 Amp. Duty cycle: 15% at 80A, 20% at 65A. Rated duty cycle: 10% at 90amps. Insulation Class: F, welding wire size is 035 to 040 inches. Includes: Welding torch, tip, grounding cord with clamp Brush / hammer, Face shield, Flux cored wire .030 inch (2 pounds). | | | Features: | |
• ETL approved flux wire welder
• Adjustable positions and cycles
• Comes with two pounds of flux wire and more
| | | Product Details: | | | Product Length:
| 21.0 inches | | Product Width:
| 13.0 inches | | Product Height:
| 15.0 inches | | Product Weight:
| 38.0 pounds | | Average Customer Rating:
|  based on 7 reviews |
| | | | Customer Reviews: | |
Average Customer Review:
 ( 7 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
25 of 30 found the following review helpful:
 Great little welderMar 22, 2010
By Joseph J. Hoyle
"Dudlyville welding"
This is a great little welder for small and medium projects.I am seasoned welding pro and this does the job of some of the high end 220 volt welders.
4 of 4 found the following review helpful:
Nice welderSep 18, 2011
By Mosin Nagant shooter
"Mosin Nagant shooter"
I bought this welder at Horror Fright tools under the Chi-town Electric name. If you want good penetration on thicker material, you should preheat the welding material with a propane torch. If you are worried about spatter, use nozzle gel, or try a different brand wire. I like my little unit, it does the small jobs just fine. This welder allows me to have both a dedicated flux core unit, and a dedicated solid core unit. I have had this unit for a few years, mine does not have a fan in it, like the new ones have.
2 of 2 found the following review helpful:
it worksJul 04, 2011
By sawman
this welder was pretty cheap i didn't expect much but it works well i have had no major problems and have used it enough to have run through 15 pounds of wire the only draw back is i have to adapt to one of only two settings high or low other than that it works great
6 of 8 found the following review helpful:
Great little welderMar 10, 2011
By midgett
I also agree that this welder does jobs that 220v welders do great welder and I can definatly say That for $129 this welder outperforms the $269 welder that you'll find at ****-mart
1 of 1 found the following review helpful:
 My gun is always hotNov 21, 2011
By binkee
I really like this unit. The main problem is that the gun is always hot without squezzing the trigger. When you turn on the power switch, be careful. don't lay the gun down near your work. It will arc like you have never seen before.
See all 7 customer reviews on Amazon.com
| | |
|
